I first finished it early, but I realized I did not put in some extension cables and my sensor would have been very inefficient.
This is what I had:
When I finally fixed this problem, I noticed that the socket I soldered onto my board had 8 pins while my micro controller chip had only 7. I had to re solder some of my connections again.
After that, I had to solder a capacitor onto my board ( this was not part of the original diagram ) and then finally, I soldered the wires onto the board.
Finally I finished the color sensor, though, I feel I am very behind.
This is my soldering work:
No comments:
Post a Comment